Inductor polarity when current path reverses in switched circuit

2 replies · 2K views · last reply
TheRedDevil18
Messages
406
Reaction score
2
Circuit schematic of an H-bridge with voltage source V, switches S1 to S4 each with an antiparallel diode D1 to D4, series resistor R and inductor L between nodes A and B, and current i marked through the inductor.

So initially S1 and S4 are closed and current flows as seen above.

Circuit schematic of a voltage source V with current i, feeding a 20Ω resistor in series with a 1H inductor between nodes A and B, with switches S4 and diodes D2 and D3 connected to terminals P and Q.


After some time S1 and S4 are open and current flows as seen above. Now I am confused about the polarity of the inductor, what if I said the current flows through D1 and D4 instead of D3 and D2 ?, would that be wrong ?
 
TheRedDevil18 said:
if I said the current flows through D1 and D4 instead of D3 and D2 ?, would that be wrong ?
wouldn't that be wrong way through the diodes ?

remember e = L di/dt . That says Polarirty across an inductor reverses when you go from increasing current to decreasing current