Low Pass: Why did my professor use frequency and not angular frequency?

2 replies · 2K views · last reply
space5678
Messages
2
Reaction score
0

Homework Statement



We are given a passive RC low pass filter with an input voltage of 5 Vrms at a frequency of 1 kHz. The resistor has a value of 22 kΩ, the capacitor a value of 100 nF. There is a current i across the resistor. (see picture below)

We are to calculate the magnitude and phase angle of the output voltage.

By the way, in the picture below is in german, so V eff means rms, I think the rest should be apparent.

Handwritten German solution for an RC low-pass filter: given U1 = 5 Veff, R = 22 kΩ, f = 1 kHz, C = 100 nF; circuit schematic with R and C and phasor diagram, with formulas for I and U2 and the result U2 = 2.07 V, φ = 23.7°.


Homework Equations



UR = R*I

Uout = I*XC

XC = I / ω*C

ω = 2*π*f (in rad/s)

The Attempt at a Solution



Analytically, this is not a problem, and I have attached the solution from the professor. My only problem is that for ω the professor used the frequency f, and not 2πf. As in:

ω = f = 1 kHz

This makes no sense to me and seems wrong. Could somebody possibly clarify what´s going on here? Thanks in advance.
 
Seems wrong to me as well. I got 0.36V.
 
  • Like
Likes   Reactions: space5678
CWatters said:
Seems wrong to me as well. I got 0.36V.

I think this must be a clerical mistake, as in all of the other examples he uses ω = 2πf. Thanks a bunch for checking! :oldsmile: