Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Engineering
Electrical Engineering
How can I adjust the roll off of my preamp design for better frequency response?
Reply to thread
Message
[QUOTE="Roy Fokker, post: 5502329, member: 573053"] Hello I am developing a low noise preamp and would like to change the roll off of my design to sharply decrease the gain for very low frequencies "1-5Hz". The results of my current design are as follows. [ATTACH=full]102231[/ATTACH] [ATTACH=full]102232[/ATTACH] I would need something that looked more like this.. [ATTACH=full]102233[/ATTACH] I understand the simple equations of changing the corner frequency and gain but I am unsure how to change the roll off. I recall I may have covered some of this in control systems but that was quite some time ago. Ideally id like to replicate the results in the above bode plot and have good response (40db) for higher frequencies. Any help is greatly appreciated! [/QUOTE]
Insert quotes…
Post reply
Forums
Engineering
Electrical Engineering
How can I adjust the roll off of my preamp design for better frequency response?
Back
Top