Pipeline bend calculation from strain gauge data

3 replies · 3K views · last reply
Endriu
Messages
2
Reaction score
0
Hi all,
I'm doing a stress analysis and I’m considering 3 buried pipelines carrying oil.

Vibrating wire strain gauges have been installed in different sections for a total of 468 strain gauges.

These have been arranged on the surface of the pipelines 120°apart:

Line drawing of a circular ring or pipe cross-section with small attachment fittings on the outer edge at the top and at the left and right sides.






This pipelines have suffered from a landslide. There has been a strain relief procedure accordingly. After that, the pipe has undergone another progressive landslide.



The data I surveyed by the strain gauges belong to the period that goes from august 2013 (start of the strain relief) to now.



Here attached an example :



(Data from a strain gauge during the strain relief procedure of the buried pipeline)





Table of strain gauge readings for an 8-inch pipeline sensor 'D' at position 'ALTO', with columns for date, temperature, measurement in microstrain, delta, temperature-corrected values, normalized values and deformation percent, covering 20/09/2013 to 31/10/2013.




I need to compare the results I have from the finite elements stress analysis of the pipeline before and after the strain relief procedure, with the strain gauges’ data.





I’m looking for a software or a standard calculation method to get the stress [N/m^2] out of the strain gauge’s output data [microstrain].

Could you please help me out?


Thank you.
 
Attachments
  • Line drawing of a circular ring or pipe cross-section with small attachment fittings on the outer edge at the top and at the left and right sides.
    upload_2017-11-16_10-53-58.gif
    2 KB · Views: 1,199
  • Table of strain gauge readings for an 8-inch pipeline sensor 'D' at position 'ALTO', with columns for date, temperature, measurement in microstrain, delta, temperature-corrected values, normalized values and deformation percent, covering 20/09/2013 to 31/10/2013.
    upload_2017-11-16_10-53-58.gif
    30.2 KB · Views: 866
Why can't you just use Young's Modulus ?
 
Last edited:
What is the orientation of the strain gages? Are they axial, circumferential, or something else?
 
  • Like
Likes   Reactions: Chestermiller
They measure axial strain.
I also need to compare the results of this measuring with the output of the Autopipe model. It gives stress, forces and moments in each point of the pipeline.