Plastic Electric Kettle and Microplastic release

[Julian_M]

Who are still using all plastic electric kettle here? The following paper says that boiling water in a plastic kettle can release over 10 million microplastic particles into just one litre of water. But I read it late and just bought last week a new $100 kettle with stainless steel inside but spout made of plastic, so I wonder if only the spout is plastic, how many millions of microplastic is released??

https://www.nature.com/articles/s44454-025-00018-w

Abstract​

Plastic products can release particles during everyday use, contaminating food and beverages and ultimately entering the human body through ingestion. However, the concentrations of these particles and the extent of human exposure remain poorly understood. While many studies have focused on characterizing the release of microplastics (MPs, > 1 μm), studies on nanoplastics (NPs, < 1 μm) remain limited due to significant analytical challenges associated with their small size. This study addressed this knowledge gap by investigating the release of both NPs and MPs from Australian-sourced polypropylene plastic kettles under normal use conditions using multiple orthogonal analytical techniques. During the initial boil cycles, the average releases were 0.011 ± 0.005 µg/cm2 for NPs and 0.032 ± 0.016 µg/cm2 for MPs. These releases decreased to around 0.003 ± 0.002 µg/cm2 for NPs and 0.013 ± 0.007 µg/cm2 for MPs by the tenth boil, stabilizing at levels below 0.002 ± 0.001 µg/cm2 and 0.006 ± 0.004 µg/cm2, respectively following 50 boils. After 150 boil cycles, the release declined significantly to 0.0004 ± 0.0002 µg/cm2 for NPs and 0.002 ± 0.001 µg/cm2 for MPs. The release of particles followed first-order kinetics, indicating that the release rate was directly proportional to the concentration of particles on the kettle’s inner surface. Although the number of nanoparticles declined over time, their size remained constant, with modal diameters of approximately 210 nm (measured via nanoparticle tracking analysis) and 580 nm (measured using Microtrac Sync particle analysis).

 

[berkeman]

Sorry, what's a "plastic electric kettle"? Can you post a link or a picture? And can you post a picture of your own version that only has a plastic spout? Do you know what the plastic spout is made of (what kind of plastic)?

Thanks.

 

[pinball1970]

Sorry, what's a "plastic electric kettle"? Can you post a link or a picture? And can you post a picture of your own version that only has a plastic spout? Do you know what the plastic spout is made of (what kind of plastic)?

Thanks.

My mother has one. Metal element at the bottom but the rest is some sort of heat resistant plastic. I will get an image.

 

[pinball1970]

At mother's today doing some work.