Resistance In Series/Parallel circuits

4 replies · 2K views · last reply
Mark Rice
Messages
37
Reaction score
0

Homework Statement


Hi, I need to find the total resistance of a circuit (attached file). I'm pretty sure it's really and straight forward but I'm a chemical engineer and this is coursework so just wanted to make sure I was doing it right.

Homework Equations

The Attempt at a Solution


Do I just simplify by adding the following to each other in series to give three resistor value (R2+R3) (R4+R5+R6) (R7+R8) then work it out using these in the parallel question? ie Rcircuit= R1 + R9 + [(1/Rtotal)=1/(R2+R3) + 1/(R4+R5+R6)] + 1/(R7+R8)]I totally appreciate they way I have just typed this was not very clear so I'm happy to explain myself more!

*Edited*
 
Attachments
  • Circuit schematic with a 48 V battery and resistors R1 (8 Ω), R2 (16 Ω), R3 (8 Ω), R4 (8 Ω), R5 (8 Ω), R6 (24 Ω), R7 (24 Ω), R8 (8 Ω) and R9 (4 Ω), with labelled voltages V1 to V4 and currents I1 to I3.
    Resistor.png
    4.5 KB · Views: 520
Mark Rice said:
Do I just simplify by adding the following to each other in series to give three resistor value (R2+R3) (R4+R5+R6) (R7+R8)
That cannot be right because R4 is not parallel to R7 and R8. But you have the right approach - collapse combinations in stages, starting with the simplest ones.
 
haruspex said:
That cannot be right because R4 is not parallel to R7 and R8. But you have the right approach - collapse combinations in stages, starting with the simplest ones.

So do I add R1 + R4 + R9 in series. Then do the parallel calculation [(1/Rtotal)=1/(R2+R3) + 1/(R5+R6)] + 1/(R7+R8)]? Sorry not done physics in 3 years so I'm a bit rusty!
 
Mark Rice said:
So do I add R1 + R4 + R9 in series. Then do the parallel calculation [(1/Rtotal)=1/(R2+R3) + 1/(R5+R6)] + 1/(R7+R8)]? Sorry not done physics in 3 years so I'm a bit rusty!

Is this what I do anyone?
 
Mark Rice said:
So do I add R1 + R4 + R9 in series.
Not R4. There's a connection with other resistors in between R1 and R4.
In general, you look for:
- two resistors in sequence with no other connection between them; if found, combine them, adding resistances
- two resistors joined to each other at both ends; if found, combine them using the parallel resistance rule
- repeat as necessary
Yes, you can combine 2 with 3, 5 with 6, and 7 with 8. What next?