Simulating Signals in PSPICE Without Re-Adding Traces

[Corneo]

Is there a way to tell PSPICE to graph a signal without having to go to Trace>Add-Trace and selecting the signals each time? If I added a signal and then change a component value slightly and run the simulation, is there a way I can refresh the signal without having to go through the add trace method over and over again?

 

[berkeman]

I don't know about PSPICE, but in MicroCAP, the plot setup is sticky. What analysis are you running (AC, DC, Transient, etc.)?

 

[Corneo]

I am trying to perform AC analysis. Thank you for your reply.

 

[berkeman]

Do you have the Student Edition of PSPICE? If so, I won'der if the sticky nature of plot setups is disabled for that edition. Maybe check out the readme/help files about setting up the plot configurations, and also the limitations of the Student Edition.

 

[kiran_ks47]

Hi frndz can anyone tell me homework to plot steady state temperature of resistor using pspice.