Solving SAT Physics: Momentum of Block Starting from Rest at 5s

AI Thread Summary
To determine the momentum of a block starting from rest after 5 seconds, the relevant equations include p=mv, F=ma, and v=at. The momentum can be calculated by substituting velocity into the momentum equation, leading to p=m(at). A constant force of 2N acting on the block results in a change in momentum of 10 kg m/s over 5 seconds. The discussion highlights the importance of knowing the force acting on the block to arrive at the correct momentum value. Understanding these relationships is crucial for solving similar physics problems effectively.
spyroarcher
Messages
13
Reaction score
0

Homework Statement


If the block starts from rest, its momentum at 5 seconds is...


Homework Equations


p=mv
F=ma
v=at


The Attempt at a Solution


When I thought about it, I was thinking about p=mv, and I had to substitute v to get a desirable answer. So I did p=m(at). However I only know the time, and I know the answer is 10 kg m/s, but I am not sure how to do it. Thanks in advance.
 
Physics news on Phys.org
"If the block starts from rest, its momentum at 5 seconds is..."

Is that the full question? If so, there is no answer.
 
Yes that is the full question, if it is impossible, how would the book get 10?
It also said p=F(change in T) for the answer
 
Sure, F=dp/dt, so ∆p=∫Fdt. If you have a constant force of 2N acting on the particle you will get ∆p=F∆t=2*5=10 kgm/s, but I don't see anything about that.
 
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Struggling to make relation between elastic force and height'
Hello guys this is what I tried so far. I used the UTS to calculate the force it needs when the rope tears. My idea was to make a relationship/ function that would give me the force depending on height. Yeah i couldnt find a way to solve it. I also thought about how I could use hooks law (how it was given to me in my script) with the thought of instead of having two part of a rope id have one singular rope from the middle to the top where I could find the difference in height. But the...
Back
Top