What Master's Degree Should I Pursue for Fiber Systems and SDH Equipment?

Thread starter hysen.gashi
Start date Feb 11, 2008
Tags

Degree Master's Master's degree

AI Thread Summary

A master's degree focusing on fiber optics or telecommunications is recommended for those interested in fiber systems and SDH equipment. Specializations in optical engineering, network engineering, or telecommunications can provide relevant knowledge and skills. Access to facilities and hands-on experience with equipment like the ALCATEL 1660SM R5 can enhance learning and job prospects. Networking with professionals in the field can also provide insights into the best educational paths. Pursuing a degree that aligns with industry needs will be beneficial for a career in fiber systems.

Feb 11, 2008

hysen.gashi

Hi every one,

I'm going to have a master, but I can not decide what to do.
I'm interestind something about the fiber systems, or something related to fibers.
Has anybody any idea what to have for theses.

Many thanks,

Engineering news on Phys.org

Feb 11, 2008

dlgoff

Science Advisor

Gold Member

What type of facilities do you have access to?

Feb 13, 2008

hysen.gashi

I'm using SDH equipment ALCATEL 1660SM R5.

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...

View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...

View full post »

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...

View full post »