Why does an ohmmeter read total parallel resistance?

  • Thread starter bibo_dvd
  • Start date
  • Tags Tags
    Parallel
3 replies · 2K views · last reply
bibo_dvd
Messages
37
Reaction score
0
Hello Guys !

My question is : why in these photos the ohmmeter reads the total resistance ??

Circuit schematic (a): an ohmmeter with probes connected across two resistors in parallel, 2 ohms and 8 ohms, between the top and bottom nodes.


Circuit schematic labelled (d) showing a multimeter set to ohms with its probes across two terminals of three resistors in parallel: 4 Ω, 2 Ω and 10 Ω.


I mean why in (a) the ohmmeter can't read the 8 ohms resistance ?

and

Why in (b) the ohmmeter can't read the (2||10 ) resistance ?

Thank you Guys ! :))
 
If you want the resistance of a component you often need to disconnect it from the circuit.

In this case the connections for the ohmmeter in (a) would give the same reading if you slid the contacts along the wires to a position as shown in (d).
 
  • Like
Likes   Reactions: 1 person
If there are many paths for current to take then it will take them. The meter just measures the amount of current that it supplies from its internal source of volts and does the Sum R = V/I. It can't know which portion of the current is going through which resistor. So you need to measure each resistor separately. This will involve disconnecting one end of the other two. (You needn't disconnect both ends.)