Work done by torque on a wrench with a nut

6 replies · 2K views · last reply
Saitama
Messages
4,244
Reaction score
93

Homework Statement


(see attachment)

Homework Equations


The Attempt at a Solution


If a force a F acts on the farther end of the wrench, the torque due to it Fl where l is the length of wrench. The work done by this torque for one full turn is Fl*(2##\pi##)
For wrench A, l=10 cm, and for wrench B, l=20cm.
Therefore the ratio of work done is 0.5. But this is wrong. :confused:
I don't understand why they have given the radius of the nut. I haven't used this information and I have no idea about where to use this.

Any help is appreciated. Thanks!
 
Attachments
  • Printed text problem: a hexagonal nut 1 cm in diameter is tightened with wrench A (lever arm 10 cm) or wrench B (lever arm 20 cm); find the ratio of work for one full turn, A to B.
    wrench and nut.png
    36.8 KB · Views: 474
If a force F is required to tighten the nut using the 10 cm wrench, what force is required with the 20 cm one?
 
Doc Al said:
Right.

But what next? Does that mean the ratio is 1?
 
Pranav-Arora said:
But what next? Does that mean the ratio is 1?
That's what I would say.
 
Doc Al said:
That's what I would say.

Thanks a lot Doc Al! :smile: