Recent content by oemmake

Hi everyone, In a current project, I'm curious about the risk of silicone tube cold welding when used with a solenoid pinch valve, such as = http://cfnewsads.thomasnet.com/images/large/454/454667.jpg What is the likelihood silicone tube will cold weld at the pinch point, if the pressure is...

Thank you again. Deep beneath the surface of admirable intellect, we are all simple creatures when food or drink is involved ;-)

Thank you again. What is CSA? Secret... ;-) but you are more than welcome to join

thank you again. heat isn't an option, nor is changing the bottle - unfortunately. I do have a little flow, just need to make improvements to the setup to increase it. Air tube to right the bottom of the bottle is a good starting point for tweaking this. I will try making a much larger...

Thank you. I thought bigger air bleed, more air flow. I was wrong. I will keep it small. The top of the air tube is inline with the spout, such that, the bottom of the bottle is raised higher than the air tube top. Perhaps I need to raise the top of the air tube so that it is much higher than...

Understand the range of viscousities. Am only concerned with milk + syrups for now and how to increase flow. Heat is not an option, but larger diameter is. Am trying that now. Still open to other ideas (i.e. larger air vent? higher air vent position) - smaller diameter air vents seem to work...

Hello everyone, I really feel out of my depth here, especially with this simple question. I'm trying to rig something up and understand why it's not working. With a pipe connected to a wine bottle sized bottle, syrup won't flow into the pipe (1cm diameter, 60cm long, down to a tap). For...