Need to convert 110v to 220v from 110 v inverter

  • Thread starter Thread starter saad ahmed khan
  • Start date Start date
  • Tags Tags
    Convert Inverter
AI Thread Summary
To convert 110V to 220V using a transformer, it's important to note that transformers can typically be used in reverse, but the specific wiring configuration matters. The discussed transformer is likely designed for 220V input and 110V output, limiting its use without modification. A qualified electrician could rewire the transformer to accommodate a 110V input and provide a 220V output. Users should ensure they understand the electrical specifications and safety requirements before attempting any modifications. Proper installation is crucial for safe and effective operation.
saad ahmed khan
Messages
46
Reaction score
0
hello every one
i just got a dc ac inverter 200w at 110v from black&decker company
which my uncle sent me
problem is all appliances here are rated at 220v-230v
so i went to look for the transformer that could convert 110v to 220v
but all the shop keepers tell me that the only transformer they have is one that converts 220 v to 110 v for 110v appliances.
i find this a bit strange can't the transformer be used in reverse.
i know for a fact that if i give 12v ac to a 220v to 12v transformer from the 12v side i get 220 v ac output
i just wnt to make sure that the same can be donne with a 110v 220v transformer before i buy it
thanks to alll
 
Engineering news on Phys.org
The transformer itself will do the job in reverse, but it sounds like it is wired into a box with a 220 volt input plug and a 120 volt output socket. Maybe a qualified individual could wire it with a 120 volt plug and a 220 volt socket output.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top