Calculating Formula Weights for Common Chemical Compounds

  • Thread starter Thread starter courtrigrad
  • Start date Start date
  • Tags Tags
    Formula
AI Thread Summary
The discussion focuses on calculating the formula weights of potassium phosphate, iron(III) oxide, and diphosphorous pentasulfide. The user initially misidentifies potassium phosphate as K2S04, which is actually potassium sulfate. The correct formula for potassium phosphate is K3PO4. After calculating the atomic masses of potassium (K), sulfur (S), and oxygen (O), the user arrives at a total of 174.254 amu for K2SO4. Additionally, the user notes that the total formula weight should include two moles of water, leading to K2SO4·2H2O, which adds 36 grams/mol to the calculation. The discussion emphasizes the importance of correctly identifying chemical formulas and accurately summing atomic masses for precise formula weight calculations.
courtrigrad
Messages
1,236
Reaction score
2
Hello all

I encountered the following problems:

What is the formula weight of:

a. potassium phosphate

b. iron(III) oxide

c. diphosphorous pentasulfide

I know that the formula for (a) is K2S04. Hence I know there are 2K's 1 S and 4 O's. After obtaining the atomic masses, I sum them all up. The answer is 212.3 amu but I don't get this.

Any help would be appreciated

Thanks!
 
Chemistry news on Phys.org
K=39.098
S=32.060
O=15.999

So:

K2=78.197
S=32.060
O4=63.998

So:

K2SO4=174.254

Do the same for the other ones.
 
The rest corresponds to two moles of water ions, as 2*18=36 grams/mol. So the total formula should be like K2SO4.2H2O.
 
Last edited:
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...

Similar threads

Back
Top