E.m.p attack- Can data & home computers survive?

AI Thread Summary
Electronics such as notebooks and PCs are vulnerable to electromagnetic pulses (EMPs), but storage mediums like USB external hard drives, flash memory, and optical discs may remain readable if properly protected. To safeguard these devices, constructing a Faraday cage or box is recommended, as it can effectively block EMPs. Devices do not need to be powered on to be affected by an EMP, and wrapping them in tin foil or storing them in a safe may provide some protection, though effectiveness can vary. For enhanced protection, reinforced concrete and proper grounding techniques can be beneficial. Concerns about air filtration and water purification systems post-attack are also noted. The use of materials like brass mesh raises questions about their effectiveness due to potential gaps, and the necessity of grounding for smaller Faraday cages is debated, with some asserting that grounding is not required. Overall, practical methods for protecting electronics and storage devices from EMPs are emphasized.
Dav333
Messages
91
Reaction score
0
Is it just the electronics devices like notebooks, PC's that are rendered useless or as well the actual storage mediums like flash memory & optical discs even when there stored away?

Would data on usb external HDD, flash memory, & dvd optical storage be readable after the attack?

What home methods can keep these storage devices safe?


Do the devices (usb flash & say notebook) have to be connected to power in order to be affected by the emp?

Would wrapping devices in a lot of tin foil & storing them in a safe be enough?


I'm not getting ready for ww3, but I'm pretty curious.
 
Computer science news on Phys.org
Certainly CDs would survive...but I'm curious about flash and hard drives too...
 
Just construct a Faraday box for your flash drives, a Faraday cage for your computer room, and in conjunction with reinforced concrete that should provide enough EMP protection. I'd be worried about air filtration and water purification systems if I was you.

Naturally an underground bunker addresses all these issues. If you consider the cost, the quality of life after a nuclear blast, and the overall damage to infrastructure, looting, and zombie Brooklynites, I'd just invest in a HAM rig, pactor modems, long lasting batteries and put them all in that Faraday cage.
 
I would like to make a small one that shields a notebook, just for fun.

How thick or heavy duty does the ground wire have to be? Would a long 10-12awg wire be enough? Couldn't I just use a copper pipe? And have it deep into the ground?

As for brass mesh, wouldn't the emp still get through the holes in the mesh?

cheers.
 
I got more info from a few non science forums on how to build a FC

But for a small box that you can hold easy, would it stll need a ground wire? Or does all the electricity just go away in the air?
 
Dav333, you don't need to ground a Faraday cage. A Faraday cage is a conducting box.

cronxeh, I'm not sure I know how this works. Blocking a pulse EMF requires a rapid rearrangement of charge in the cage. Resistance impedes charge rearrangement. Also, conduction alone doesn't block magnetic fields. Is this an issue?
 
Would storing devices in a car & microwave work?
 
Dav333 said:
I would like to make a small one that shields a notebook, just for fun.

How thick or heavy duty does the ground wire have to be? Would a long 10-12awg wire be enough? Couldn't I just use a copper pipe? And have it deep into the ground?

As for brass mesh, wouldn't the emp still get through the holes in the mesh?

cheers.

I suggest wheels - to help you move it about during the day.
 
Just curious, would a device housed in rubber block out the electricity? Or some of it?
 
Back
Top