Light amplification jet engine?

AI Thread Summary
The discussion centers on the concept of a light amplification jet engine that utilizes focal reflectors and strategically placed antennas for electromagnetic field amplification. The proposed design involves bending light with a parabolic reflector through a coiled laser chamber to enhance propulsion. Participants express interest in the hypothesis and the need for mathematical modeling to support the concept. The engine could potentially operate by either expelling energy or drawing it in. Overall, the idea presents a novel approach to propulsion technology.
TimeContinuum
Messages
4
Reaction score
0
Using a series of focal reflectors, built in antenna strategically placed for proper phasing the EMF amplification system. Kinda like a space hyper engine. Possible? I can draw some blueprints I think.
 
Engineering news on Phys.org
That sounds interesting to me. I would like to hear more about your hypothesis.
 
I need to incorporate the math into all my shapes, but I got a general vision I just need to model it. It's New Years tonight so I think I'm heading out. But the idea is to bend the light using a parabolic reflector through a coiled laser chamber and amplify it out the exhaust. Which can be operated as firing away from it's greatest source energy, or pulling towards it. Onboard power systems for sure.
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Sine wave power amplification question
Replies
4
Views
2K
Model electron movement in an electric field (Magic Eye tube)
Replies
2
Views
3K
Calculating equivalent horsepower for a jet engine
Replies
7
Views
6K
Quadrant photodiode selection advice
Replies
1
Views
2K
High-energy LC oscillatory discharge: what kind of switch?
Replies
19
Views
1K
LC Reactive elements cancel cause huge V drop. High voltage
Replies
12
Views
2K
Calculate Frequency of Flat Spring Steel for Reed Valves in a Pulse Jet Engine
Replies
26
Views
5K
Circuit analysis via polyhedron
Replies
5
Views
2K
Can a Railgun-Powered Ramjet Solve the Challenges of High-Speed Travel?
Replies
4
Views
2K
What do I study in school for Lorentz Force Propulsion R&D?
Replies
4
Views
2K

Hot Threads

Recent Insights

Back
Top