Is Dyeing a Dog with Kool Aid Safe?

  • Thread starter Thread starter Yayfordoritos
  • Start date Start date
AI Thread Summary
The safety of dyeing dogs, particularly for a temporary event like a Super Bowl celebration, is debated among pet owners. Opinions vary widely, with some asserting that it's safe while others warn against potential risks. Key factors influencing safety include the individual dog's temperament and the owner's willingness to manage the process. Consulting a professional dog groomer or stylist is recommended for tailored advice, as they possess expertise in safe grooming practices.
Yayfordoritos
Messages
23
Reaction score
1
Is it safe? I hear so many different opinions on the internet, that some people say it's perfectly safe, and others say it's bad for the dog. Me and my sister were thinking of dying my mom's two maltese's if the Bronco's make it to the super bowl, one blue and one orange. It would only be for one day. I figured a chemist or a chemist major would know the correct answer.
 
Chemistry news on Phys.org
Is it safe? It really depends on the dog's personality. And on your mom's personality and patience.
 
If you can find a dog groomer/stylist (yes, they exist), that's probably the best person to ask.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top