Control Systems Engineering: Books to Master the Basics

AI Thread Summary
Key recommendations for mastering Control Systems Engineering include essential topics such as Laplace transforms, Bode plots, and Nyquist criteria. A suggested resource is the book "Control System Engineering" by Norman Hayes, which is noted for its comprehensive coverage. Additionally, a link to MIT's OpenCourseWare provides valuable lecture notes and readings for further study. The community appreciates these resources as they significantly aid in understanding the fundamentals of control systems. Overall, these texts and materials are crucial for anyone looking to strengthen their knowledge in this field.
ng
Messages
31
Reaction score
0
hi,

Can someone suggest some good books in Control Systems engg. which includes all from laplace to bode plots,nyquist etc etc.

Thanx for any help.
 
Engineering news on Phys.org
This link points to that information. The "readings" link recommends texts.
http://ocw.mit.edu/OcwWeb/Electrical-Engineering-and-Computer-Science/6-003Fall-2003/LectureNotes/index.htm
 
hi es

that is a very useful bit of info.I really needed it.Thanx for the same.
:smile:
 
title: control system engineering, 3rd ed.
author: norman hayes
 

Thread 'What happens if shielded cable has short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

I am trying to stabilize laser frequency with PID controller
Replies
14
Views
2K
What is the "observer" in PID control?
Replies
12
Views
3K
Where is the 'Origin' on a Bode Plot?
Replies
8
Views
3K
Can a Square Wave Tachometer Drive be Powered by a Sine Waveform?
Replies
16
Views
3K
Concept of 'encirclement' in Nyquist plot
Replies
1
Views
3K
Cost of a 50 km range RC system & Type of Antenna
Replies
12
Views
2K
Interpreting electrochemical impedance spectroscopy (EIS) circuits
Replies
5
Views
2K
Help with waveform control: frequency, phase and amplitude
Replies
46
Views
5K
New to PhD in Control Systems?
Replies
3
Views
824
Research Student in Mechatronics Engineering
Replies
1
Views
445

Hot Threads

Recent Insights

Back
Top