Question on hypothetical pure O2 atmosphere

AI Thread Summary
The discussion centers on the feasibility of long-term colonization of Mars, specifically the extraction of oxygen from Martian ice to create a breathable atmosphere. One participant initially claims that 670 million metric tons of ice would be needed to achieve a 20 kPa atmosphere of pure oxygen. However, this calculation is corrected, revealing that approximately 870 million million metric tons of ice would actually be required. The conversation also touches on the stability of a pure oxygen atmosphere, noting that oxygen is highly reactive, raising concerns about the implications of such an atmosphere on Mars. The calculations and assumptions regarding the mass of ice needed are critically examined, highlighting the significant challenges involved in terraforming Mars.
DHF
Messages
247
Reaction score
32
Hello,

Due to all the buzz by Mars One, my friend and I have been discussing hypothetical possibilities for long term colonization of Mars. He suggests the only long term solution is to extract O2 from the Ice on Mars and give the planet a breathable atmosphere. he did the math and calculated that in order to give the planet a 20kPa atmosphere of pure O2 you would need 670 Million metric tons.

I am curious as to how stable a pure O2 atmosphere would be. I know it is a very reactive element so what would happen if you had an atmosphere of pure O2?

Thanks for any insights.
 
Chemistry news on Phys.org
I double checked with him, I was in error, his calculation of 670 Million Metric Tons was based on an end result of 16kPa, not the 20 I stated.
 
The calculation is off by a factor of 1 million, a factor of 2 does not matter here.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top