- #1
Ian_Brooks
- 129
- 0
Hi PF Designers,
Wasn't too sure if this would belong in the Electrical engineering forum but here goes.
I'm designing a prototype for my thesis that will read in sensory data wirelessly to a MATLAB script. This sensory data is riddled with noise, however important data is contained in the High frequency components of the signal as well.
Hence I was naturally going to use a Savitzky-Golay FIR filter in matlab. However I was wondering if I could perform further noise reduction techniques on top of this and still preserve the high frequency component that I saved.
Thoughts, dilemmas, discussion, tid bits of help?
Wasn't too sure if this would belong in the Electrical engineering forum but here goes.
I'm designing a prototype for my thesis that will read in sensory data wirelessly to a MATLAB script. This sensory data is riddled with noise, however important data is contained in the High frequency components of the signal as well.
Hence I was naturally going to use a Savitzky-Golay FIR filter in matlab. However I was wondering if I could perform further noise reduction techniques on top of this and still preserve the high frequency component that I saved.
Thoughts, dilemmas, discussion, tid bits of help?