- #1
fnumechHV
- 1
- 0
Hello,
I am seeking advice on how to use an accelerometer as a switch on a CubeSat form factor. Incase you are unfamiliar, a cubesat is 1cm cube device designed to go into space. The problem is that the CubeSat must not have any electronics active during launch. I am seeking to use an accelerometer to act as a switch as soon as the device reaches 0 g at apogee. Any ideas?
I am seeking advice on how to use an accelerometer as a switch on a CubeSat form factor. Incase you are unfamiliar, a cubesat is 1cm cube device designed to go into space. The problem is that the CubeSat must not have any electronics active during launch. I am seeking to use an accelerometer to act as a switch as soon as the device reaches 0 g at apogee. Any ideas?