- #1
SlimJ87D
- 6
- 0
Mcmaster carr's gears are a bit too wide for my design.
I need a pair of gears to have a ratio of .31, that is around .7" to 2.38"
The widths for the gears can not be any larger than .5" and ideally even less, at Mcmaster Carr they are about 1"
Have to be made of steel.
Cannot be any larger than 2.4" outside diameter.
I need a pair of gears to have a ratio of .31, that is around .7" to 2.38"
The widths for the gears can not be any larger than .5" and ideally even less, at Mcmaster Carr they are about 1"
Have to be made of steel.
Cannot be any larger than 2.4" outside diameter.