- #1
Helpls
- 10
- 0
wrap a wire around a cone [urgent]
Something like this: http://img11.imageshack.us/img11/6627/conewire.jpg
http://img11.imageshack.us/img11/6627/conewire.jpg
Uploaded with ImageShack.us
Hello everyone, i need help solving a problem I'm facing so i can continue my project. So the problem I'm facing is that i got a cone 60cm height and 45 cm base diametre, and i want to wrap a wire with (0,3±0,1)cm diametre around the cone, but i must do it in order to get the same length of wire in the top and in the bottom, so i will need to gradualy increase the gaps between the wires, i was thinking in start with 0,5cm of gap between the first and second winding. But i don't know how to do this right in order to get the same length of wire in the top and bottom. Please help me , i want this so bad but i simply don't know.
Something like this: http://img11.imageshack.us/img11/6627/conewire.jpg
http://img11.imageshack.us/img11/6627/conewire.jpg
Uploaded with ImageShack.us
Last edited by a moderator: