Register to reply

Reinforce concrete column under biaxial bending

by mohamadh95
Tags: bending, biaxial, column, concrete, reinforce
Share this thread:
mohamadh95
#1
May9-14, 03:00 AM
P: 38
I've made a program with Mathematica that will compute the load along with the moments sustained by a concrete column given the stress block area and orientation(in other word the neutral axis center location and the angle it makes with the horizontal). However I am facing an issue with setting the upper limit for the distance of the neutral axis to the top left corner as shown in the attached picture. I would like if anyone could help me.
Attached Thumbnails
Screenshot 2014-05-09 10.55.44.jpg   Screenshot 2014-05-09 10.55.53(2).jpg  
Phys.Org News Partner Engineering news on Phys.org
An innovative system anticipates driver fatigue in the vehicle to prevent accidents
Squink personal factory aims to make circuit prototyping easy
Catching grease to cut grill pollution
paisiello2
#2
May10-14, 12:34 PM
P: 558
Are you breaking the section down into layers?
pongo38
#3
May10-14, 05:21 PM
P: 696
Please clarify your question.


Register to reply

Related Discussions
Neutral axis-Biaxial bending General Engineering 4
Concrete column and ultimate compressive stength Engineering, Comp Sci, & Technology Homework 3
Replacing Reinforced Concrete Beam-Column Joint General Engineering 0
Stress in Reinforced Concrete Column Mechanical Engineering 9
Stress in a concrete support column Advanced Physics Homework 5