Recent content by AdeJS

  1. A

    Dynamics of Taper Roll in Metal Industry: Calculating Forces & Movements

    At the moment neglect slippage. so the flanges are rotating at a same speed only in opposite direction. when this is clear I'll go one step further and will have a velocity difference creating slippage. The roller as well as the flanges are made of steel. what I'm looking for is a formula I...
  2. A

    Dynamics of Taper Roll in Metal Industry: Calculating Forces & Movements

    I apreciate the reply, but I don't agree with you. The static friction is the maximum friction. so if static the stays in its place the static friction is larger than the outgoing force created by the flanges pressure. when the flanges start to turn the static friction turns in a rolling...
  3. A

    Outgoing dynamic force: taper roll between flanges

    please see other topic. https://www.physicsforums.com/showthread.php?t=615293 this one can be closed!
  4. A

    Dynamics of Taper Roll in Metal Industry: Calculating Forces & Movements

    hmm found the other topic. hope someone can help me
  5. A

    Outgoing dynamic force: taper roll between flanges

    Maybe I've asked this before but I can't find the topic any more. I'm looking for a way to calculate the outgoing force of a taper roll between two spinning flanges. Staticly this is not so difficult by using the force of the flanges clamping the taper roll and the roll angle. When the...
  6. A

    Calculate Forces on Tools & Workpieces in Sheet Metal Spinning

    you could also see is ANSYS would do the job!
  7. A

    Dynamics of Taper Roll in Metal Industry: Calculating Forces & Movements

    Sorry guys, As I understand there is no introduction topic or what so ever so I'll do it here. Don't want to burst in without introducing myself. Hi I'm Andrew from the netherlands and during my websearch for a solution to my problem came across this forum. After finishing my mechanical...
Back
Top