Ok here goes. It's been a long time since I've done anything like this and i just can't remember what to do.
I'e got a beam 167.5mm long. It is supported at 24.5mm along the beam.
6600kgf acts at one end of the beam.
F1 acts at 128.5mm along the beam. F2 acts at 167.5mm along the beam.
F1...
Quick question that's causing a lot of headaches at the moment.
Ive got two horizontal springs with a mass in the middle.
The springs are preloaded.
I get that the springs are in parallel and the effective stiffness is the sum of the stiffnessess.
If the springs are preloaded, is the preload...
Hi,
I'm looking for some help regarding heat transfer through some sandwiched materials.
We have a pneumatic cylinder with the stainless steel 303 cylinder rod attached to a block of aluminium 6082 t6 50mm high x 40mm wide x 10mm deep. This block is attached to a block of polyurethane, shore...
Thanks OldEngr63,
How does calculating the angular acceleration help me resolve the equations of motion?
Also say for example i take a cut through the vertical part of the lever and look at the bottom L section, if i know the applied force F how would i go about calculating forces on the cut...
Hi guys,
I'm new here and this is my first post so apologies if its in the wrong location or anything.
My post is not in regards to a direct question as such but i am more looking for general advice and guidance on how to tackle a problem. I am working on a project that involves lifting...