I was wondering how to calculate the magnitude and phase response of any circuit that is neither Low-Pass,High Pass nor Band-Pass. I am asking this because i haven't found anything relevant in any textbooks so far , since the only use standard filters.
e.g an AC circuit consisting of an AC...
I meant how would each of the mentioned values ( entropy , momentum , energy ) would change for both a viscous and an inviscid fluid for each phase : a ) at the top of the dam , b) while falling c) when it drops d) after the drop
Hello there ,
could you please explain to me what would happen to an inviscid/viscous incompressible flow (energy,momentum and entropy wise)falling from a height ? ( i.e a dam )
Thanks;)
Thank you very much for your answer, although i have to say it wasn't what i expected, which is not your fault . It just seems to complicated.
Would anything change if we said that the container is thermally insulated ?
Let's assume that we have a non insulated glass container where there is any gas inside.
If the beginning pressure is equal to the atmospheric pressure and then the gas is pressurized at ,say, 3 Bar . Then what kind of process would occur if we let a small amount of gas escape over a very...
Thank you for your reply.
Since it says that we are only interested in the change in PE then PE = 3mg right ?
so the change in energy is 50 J therefore 50 - 3mg = constant ?
What about kinetic energy ?
Homework Statement
A block of mass 10kg moves along a surface inclined 30° to the horizontal. The centre of
gravity of the block is elevated by 3m and the kinetic energy of the block decreases by 50J.
The block is acted upon by a constant force Rparallel to the incline and by the force of...