Recent content by kazi

Well even without scaling (on the picture it is about 100x) this 0,1 mm deformation is slightly visible. I was a bit worried about the simulation results vs books telling me there is such no deformation. But now that you have explained what is happening I understand this is not to worry about...

Hi everyone, I have a 100 mm long, solid cylinder (shaft) with a diameter of 20 mm. The base circular surface at one end is fixed and the other end gets a torque of 100Nm. The SolidWorks simulator (URES) results show that the diameter of this shaft increases by about 0.1 mm due to the...