Recent content by kevinlam87

i think i have determint the module...I run into a problem though...I tried to work out the dynamic factor so I could apply into the eqution...the graph infront of me doesn't show the dynamic factor for grade 8 quality as it ran out

Design the shaft assembly of gear 2 with the following information: Gear: The specification of the involute helical gears are as follows Pressure angle: 20 degrees Torque acting on gear 1, T1= 95500Nmm Number of teeth: N1= 55(gear1), N2=135(gear 2) Helix angle= 15 degrees Tooth Width b=...