I did some research, looks like this isn't a very used converter, but to me it was pretty much the only one available to suit my needs, unless I want to order directly from a manufacturer in which case the shipping alone would cost ten times more than the chip itself.
So.. when I build this...
Take a look at this data sheet http://www.datasheetcatalog.com/datasheets_pdf/T/P/S/6/TPS61032.shtml" and tell me this:
There are multiple pins assigned for the same function. there are two pins for SW and three for PGND and VOUT each. Do I only need to connect one of each pins or connect them...
I found a schematic from the internet that was claimed to generate a square waveform at a decent frequency. I built the thing but it doesn't seem to work at all.
I'll attach a picture of the schematic. Could you tell me what's wrong with it and if there is any other relatively easy way to make...