Recent content by loststudent123

thank you :)

what should i put in for applied torque?

its degree so its one degree is the max angle of twist and its over the length of 20 diameters

my lecture gave only those equations so I am not sure of anyothers and i fixed the angle of twist however.

Homework Statement A rule often used in shaft design states that the angle of twist shall not exceed 1° on a length equal to 20 diameters. What stress in the material does this imply if the modulus of rigidity is equal to 80 × 103 N/mm2 ? Homework Equations T/J=Gθ/L=τ/r J=π?32(D^4-d^4)[/B]...

A rule often used in shaft design states that the angle of twist shall not exceed 1 on a length equal to 20 diameters. What stress in the material does this imply if the modulus of rigidity is equal to 80 × 103 N/mm2 ? was wondering if anybody had an insight on how to do this ? have tried a...