Recent content by sankafola

ok will try that

so that is why i decided to make my own Generator :)

well they wouldn't say at what RPM i made a youtube video on it :) so you tell me what is the best way to find out i would say the voltage at the end of this video i tested at 2000 RPM i got 376 v DC

It’s because I bought it rated 30kw 600volts dc 50 amps

But if am testing without load I should be able to get the 600 v dc why am only getting 400 v dc at 2000 rpm

i have a generator here 30kw what is the proper way to test if its really 30kw can you tell me , without a load , its suppose to output 600 v DC 50 Amps what is the best way to test if its really 30kW ?

@sophiecentaur i have that Motor LG washer machine and as a prototype i put on the outter surface NYD 52 NSNSNS... and i made a small coil " Anti lenz " ONE coil and it was making 24 volts 1 amp and raising the input of the motor 3 watts only so open circuit 24 watt for 3 watt and my core was...

can you explain why ? what if its nanocrystal ?

@Baluncore hi, so what is the rule to match the coil with the poles? i have 48 poles NSNSNSNSN... do i need 48 coil ? the LG motor have 36 coil and 48 poles the coil in the LG motor is not good to do a generator , max is 1200 Watt , so what i want to do is i do an ANT LEnz coils a new design...

a lot of unknown this way , if i assume the Φ ( thickness of the wire ) =0.72 x Squar of the amps so if i want 2 amps then the thickness of the magnet wire need to be 1 mm is that right ? and if i assume the section to be 15 cm square then n=k/s so k=45-50 so number of turns is = 45/15 = 2.8...

is there is a formula for coil ? so i can put the right wire gauge and the right turns ?

what wire gauge ? let say its gauge 18 how many turns to do 50 volts? if the section is 15 square cm

Hello All, am trying to make my own Generator 5kw , am trying to find out how many coils i need , i have a drum which is full of magnet 48 NSNSNS... for the coil i have 8 cores U shape U86A size of section is 15 cm ( 56x28mm ) how to find out what gauge for the magnet wire...