Okay sounds very pertinent. I should have mentioned at the start that the engineering specification for this is that the fixture needs to have a natural frequency of greater than 100Hz. Considering all the advice you have given me, would I be wrong to say that I can just put one motor providing...
Thank you. That was helpful . I have two more queries That I'd like your input on if convenient .
1) if I place 4 of these motors on my base plate would it create a series effect ie would my frequency then be 166*4 Hz?
2) how do I account for the direction of vibration effect ie would my test...
Hi Mech_Engineer,
The motor has a spec of 1G vibration and an operating voltage of 2.5-3.5V. Also the spec states that the weight within vibrates at a frequency of 10000RPM. Any of this information helpful?
Hi all,
My fellow students and i are working on a university project. We are making a fixture and doing some vibration testing. We purchased a few disk motors and we are attaching those to our fixture. The set up is fine and we have been able to get the motors running and been able to vibrate...
Hi all,
I am a student designing a camera fixture for my senior design project. We are halfway through our project right now and we are trying to do some validation stuff for our fixture.
One of the requirements for our fixture is for it to withstand 6 g's of shock during...