Calculate IC equalizer frequencies and gain

AI Thread Summary
The discussion focuses on calculating the frequencies and gain in an AC circuit using the BA3823LS equalizer IC, specifically how capacitors and resistors affect frequency response and gain. The user seeks equations to determine the defined frequencies and the corresponding boost or cut in gain (dB) for each frequency. They reference a datasheet that includes application examples with center frequencies and gain values but lack the necessary equations to perform these calculations. The user confirms that the capacitors in their diagram match those in the datasheet example, indicating they are relevant for their analysis. Overall, the inquiry centers on understanding the operational principles of the equalizer and how to quantify its effects.
tritonas00
Messages
2
Reaction score
0
Homework Statement: Calculate frequencies/gain in an AC circuit given capacitance and resistance
Relevant Equations: Looking for them :P

Hi! I have this diagram:

eq.png


BA3823LS monolithic, five-point stereo graphic equalizer IC is used. Is there any way to calculate the frequencies (hz) that are defined and how much boost/cut gain (db) is applied in each frequency? If i'm reading this correctly the capacitors (C56, C55, ...) are used for setting the frequencies and the resistances on the side are used to cut/boost those frequencies?

I don't know anything about electronics and all the info i have is https://datasheetspdf.com/pdf-file/233435/Rohm/BA3823LS/1 where application examples of the BA3823LS are shown with the 5 center frequencies and some min/typ/max gain values.

This is not a homework, just trying to figure out what the above equalizer actually does. Thanks for your time and sorry if i'm posting this in wrong section.
 
Engineering news on Phys.org
Ok, about the frequencies i just noticed that the capacitors used in the example application (pdf) are the same as the diagram shown. Show they would probably be the same:

fre.png


So what remains is the gain (db), how much they boost or cut those frequencies. For example those, if i'm reading this correctly:

res.png


Is there an equation to find the db based on those two values?
 

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Frequency analysis of transistor amplifiers
Replies
6
Views
2K
Calculate Frequency of Flat Spring Steel for Reed Valves in a Pulse Jet Engine
Replies
26
Views
5K
Calculating Required Gain for Fifth Intermediate Amplifier
Replies
3
Views
2K
I How do I calculate the expected Gain?
Replies
1
Views
1K
What is the Frequency for Unity Loop Gain in Low-Pass Amplifier with Feedback?
Replies
4
Views
2K
Voltage gain of an emitter follower (BJT Common-Collector)
Replies
5
Views
3K
Discrete Differential Amplifier
Replies
6
Views
2K
Bandpass Filter Homework Statement
Replies
6
Views
2K
Engineering How Do You Calculate Gain and Cutoff Frequency in a Switched Capacitor Circuit?
Replies
5
Views
2K
Designing a Differential Oscilloscope Preamplifier
Replies
4
Views
4K

Hot Threads

Recent Insights

Back
Top