I found this circuit board in an old toy car. What does it do?

  • Thread starter Thread starter leVanw
  • Start date Start date
  • Tags Tags
    Board Circuit
AI Thread Summary
The circuit board found in the old toy car is likely designed for low-cost electronics in remote-controlled (RC) vehicles. Without the corresponding remote control, the board is essentially unusable and considered electronic waste. For those interested in building an RC car, purchasing a complete kit with a manual and all necessary components is recommended. This approach ensures proper functionality and avoids the pitfalls of mismatched parts. Understanding the purpose of such circuit boards can aid in future electronics projects.
leVanw
Messages
6
Reaction score
0
1000008292.jpg

I found this circuit board in an old toy car. Does anyone know what it is for and how to use it?
 
Engineering news on Phys.org
Kind of obvious but looks like low cost electronics for remote controlled toy car.

Without the proper matching remote it's more or less just a piece of electronic waste.

If you wish to build an RC car, then you may consider to purchase a cheap kit, in proper condition, with a manual and every necessary piece included.
 

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Battery protection circuit board
Replies
2
Views
1K
Recognize these inrush current limiting devices?
Replies
2
Views
1K
Vacuum cleaner series universal motor triac control board
Replies
3
Views
502
Kids Ride on Toy Car Battery/Voltage
Replies
5
Views
3K
Magnetic levitation board not working
Replies
12
Views
2K
Why Does My Varactor Diode Test Circuit Behave Differently on a Breadboard?
2
Replies
93
Views
7K
Circuit Board Design: Basics of Designing a PCB
Replies
11
Views
4K
Why would disconnecting the positive cable first on car battery cause sparks?
2
Replies
54
Views
11K
How Can I Record a Raw Analog Signal with an Arduino Using a Circuit Board?
Replies
5
Views
2K
Locate & Disable Wifi Transceiver on Modem Circuit Board
Replies
8
Views
2K

Hot Threads

Recent Insights

Back
Top