Controlled (Thyristor) Three-Phase Full-Wave Rectifiers in LTspice

5 replies · 2K views · last reply
Maverickans
Messages
7
Reaction score
1
Hello, I'm trying to simulate a 3-phase, 6-pulse Thyristor Bridge Rectifier on LTspice, but I can't seem to get the results. Here is what I have so far. Could someone please guide me on this? Thank you!

LTspice schematic of a three-phase six-pulse thyristor bridge rectifier with six PULSE gate sources, three AC voltage sources labelled SINE, and a load resistor R1 with output node OUT; a text box lists pulse timing and .param settings.


LTspice simulation plots: three-phase sinusoidal source voltages V(a), V(b), V(c) at top, rectified output V(out) with gated pulses in the middle, and line-to-line voltages V(a,b), V(b,c), V(c,a) at bottom, over 0 to 200 ms.
 
Last edited by a moderator:
Could you please attach a copy of your schematic filename.asc to a post. Do it by adding an extra extension, to make a text file called filename.asc.txt

You can do the same with the plot filename.plt extending it to filename.plt.txt

Then we can remove the .txt extensions, and run your simulation without the problems of poor picture quality.
 
The SCR you are using is not in my old LTspice library.
What model of SCR are you using ?
Where did you get the files for that SCR ?