Drawing mechanics diagrams in Visio

  • Thread starter medwatt
  • Start date
2 replies · 5K views · last reply
medwatt
Messages
122
Reaction score
0
Hello,
I want to draw mechanisms and some dynamics diagrams as shown in the pictures attached but have no idea. I have Visio but there doesn't seem to be a Mechanics toolbar.
Any help will be appreciated.
Thanks
 
Attachments
  • Mechanics diagram of a rotating shaft system: a disc of mass m1 g hangs on the left end O1 with distances d1 and b and d2 marked, bearings A and B with reaction forces X and Z labelled, a rod O2 to D inclined at 60 degrees with weight m2 g at C2, and a moment M at O2.
    5_101.jpg
    24.6 KB · Views: 474
  • Kinematic diagram of a linkage mechanism with pivots O1, A, K, B, O2, and D, a sliding block E in a guide, applied forces Q and F, moment M, and angles alpha, beta, gamma, delta, phi.
    5_105.jpg
    21.5 KB · Views: 454
I use Inkscape a lot.

It's very well suited for mathemical and technical drawing thanks to its "magnet" feature that allows you to connect and align all the shapes perfectly.
However, it's not physics-oriented, but since it's a vector graphics software, you can get very smooth and clear results.

You'll just have to draw everything from scratch.
> Demands more work, but provides more freedom!