Find voltage using nodal analysis

4 replies · 2K views · last reply
Martin V.
Messages
10
Reaction score
0

Homework Statement


Assignment: Find V_2 using Nodal Analysis

Homework Equations


KCL
U=R*I

The Attempt at a Solution


- Chosen reference node
- Assigned node voltages
- Applied KCL to each non-reference node
- Solve system of equation
- Checked equations for obvious errors

See circuit drawing, node labels and assumed current direction in Nodal.png. Equation and solution of equation is to find in Nodal 2.png.

The right result should be that V_2=13,84V and not V_1 as I get.
 
Attachments
  • Circuit schematic with a 10V source feeding resistors R1 (100) and R2 (300) at node V1, then R3 (100) and R4 (166.7) in series along the top to node V2 and V3, with R5 (2k) to ground and a 20V source on the right; currents I1 to I5 and a ground symbol are labelled.
    Nodal.png
    11.7 KB · Views: 637
  • Handwritten-style nodal analysis worked solution: KCL equations at nodes 1 and 2 with resistors 100Ω, 300Ω, 166.7Ω, and a solved result V1 = 13.84V and V2 = 4.615V.
    Nodal 2.png
    5.8 KB · Views: 583
Not sure if this is the only mistake but KCL at node 2 is wrong...

Personally I prefer to write for my KCL equations to sum to zero so I would write...

Assume current leaving a node is +ve then..

+ I4 + I5 = 0
and
I4 = -I5

You might be tempted to skip steps but you have to be very fussy about the signs when applying KCL or KVL. I find I make fewer mistakes if I write my equation so it sums to zero and don't take shortcuts.
 
  • Like
Likes   Reactions: Martin V.
Your working for KCL at node 1 looks correct but I would write..

Assume current leaving the node is +ve..

-I1 + I2 +I3 = 0

Then rearrange it. It may seem fussy but by sticking to this version of the KCL definition I find I make few mistakes.
 
  • Like
Likes   Reactions: Martin V.
Both KCL-equations is wrong. With #2 is found the error in the equation around node 2. For node 1 were the 10 V battery not included in the equation. With the two change I get the correct answar - thanks! :)
 
Attachments
  • Circuit schematic with nodes V0, V1, V2 and V3 and resistors R1 to R5, a 10V battery, a 20V battery, and currents I1 to I5, followed by handwritten-style nodal analysis equations solving for V1 = 10.24V and V2 = 13.9V.
    Nodal 3.png
    52.5 KB · Views: 640
I agree with Martin V. I found ##V_1\approx10.2426...(V)## and ##V_2\approx13.9012...(V)##.