Finding node voltages in a circuit with a current dependent voltage source

3 replies · 3K views · last reply
Evales
Messages
53
Reaction score
0
Hey guys,

I'm trying the analyze a circuit, I have the answers I should be getting but they're way off what I'm getting when I'm trying to work it out.

I think I might be approaching it from the wrong angle, does anyone have any suggestions as to where I might start.

I'm trying to find v3 and v2 (the 2nd and 3rd nodes).

At the moment I'm doing the KCL for each node, and getting three equations with all the node voltages as well as the currents through the voltage source and the current dependent voltage source as variables.

I then do the mesh analysis which I substitute into the original equations, which has given me some pretty crazy answers. The latest being:
v3=696V

v3 is supposed to be 80V!

It's driving me insane, and the way I'm doing it means it takes me an hour to redo it everytime.

Any help would be much appreciated.
 
Attachments
  • Handwritten circuit schematic with nodes V1, V2 and V3 to ground: 50V source and 40Ω resistor at V1, 5Ω series resistor with current ia between V1 and V2, 50Ω resistor at V2, a current-dependent voltage source V = 10ia between V2 and V3, 100Ω resistor and 4A current source at V3.
    Circuit1-4.jpg
    31.4 KB · Views: 558
Thanks! I thought it would have something to do with a supernode but we've only done them in parallel, I wasn't sure it would still apply.

Also in my last three tries I let v1= 50V, but this time I didn't. Clearly time to head to bed lol.

Thanks again.
 
Look at my solution.
We have a one supernode, and this means that we treat V2 and V3 as a one supernode.
We short CCVS and use nodal analysis.

Circuit schematic with 50V source, 40Ω, 5Ω, 50Ω and 100Ω resistors, a 4A current source and node labels V1, V2, V3 and Ia marked in red, with the lower half showing the same circuit with current arrows added.


Now we write KCL for our supernode, 4A current source entering node and remaining currents leaving the node.

4A = V3/100Ω + V2/50Ω + (V2 - 50V)/5Ω (1)

And one additional equation

V3 - V2 = 10*Ia (2)

And that's the only think we need to solve this circuit.
 
Attachments
  • Two circuit schematics: the upper one shows a 50V source, 40Ω and 5Ω resistors, a 50Ω resistor and a 100Ω resistor with nodes V1, V2 and V3, a current-controlled source labelled 10×Ia, and a 4A current source. The lower one is the same circuit with the dependent source shorted, showing currents Ia and 4A.
    22.PNG
    5.2 KB · Views: 663