Finding node voltages with nodal analysis when a node has no elements

1 reply · 2K views · last reply
AxeWhyZ
Messages
3
Reaction score
0

Homework Statement


Find V1 and V2 by Nodal Analysis

Circuit schematic with a 240 V source, 3 ohm and 6 ohm and 12 ohm and 30 ohm resistors, a 10 A current source and a 60 V source, with nodes 1, 2 and 3 marked in red and voltages V1, V2 and Vy labelled.


Homework Equations

The Attempt at a Solution


In order to find V1 and V2, I will have to define voltages at node 1 and node 2 as Vx and Vy, so that when I apply KCL at node 1, I will get:

(Vx-240)/3 + (Vx-Vy)/6 + 10=0

While there is a 30 Ohm resistor at node 2 where I can label the voltage Vy, where should I label the voltage Vx when there is no element? Is this the right way to label the voltage Vx:

Circuit schematic with three marked nodes: a 240 V source and 3 ohm resistor feed node 1, 6 ohm and 12 ohm resistors link to node 2, a 30 ohm resistor runs down from node 2, a 10 A current source sits between nodes 1 and 2 on top, and a 60 V source connects to node 3.


And if it is the right way, what is the logic?
 
I would draw an arrow and label that, but yes, this is the right approach if you want to reference your Vx to the lower node (a good choice).