How Can I Analyze the Frequency Response of an Electric Current Shell in Comsol?

AI Thread Summary
To analyze the frequency response of an electric current shell in COMSOL, it's essential to conduct a frequency domain study. Users should ensure that the frequency solver is properly configured before proceeding. The results can be visualized using the result modules available in the software. Proper setup of electrodes, such as gold, is also crucial for accurate frequency response analysis. Following these steps will help in generating the desired frequency response diagram.
sonekralj
Messages
1
Reaction score
0
Hello people, i need help with frequency domain study in electric current shell modul. I have one IDC and i have electrodes from gold, and i don't know what should i do to see my frequency response on diagramm?
Does anyone has any idea?
 
Engineering news on Phys.org
you can find it in the result modules. before that, make sure you used the frequency solve.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

COMSOL simulation of a 3D Ferrite Bar Numerical Model For Magnetic Flux
Replies
5
Views
3K
Finding the resonant frequency of this "discriminator" demod circuit.
Replies
2
Views
2K
I Need a good idea : 3D simulation of Inductive wireless power transfer
Replies
6
Views
2K
How can I adjust the roll off of my preamp design for better frequency response?
Replies
3
Views
2K
(signal processing)Time domain vs Frequency domain, totally confused
Replies
8
Views
16K
I have a question on the phase of a frequency response
Replies
1
Views
1K
Cannot lock reference signal on lock-in amplifier
Replies
5
Views
2K
Understanding the Image output in Frequency Domain
Replies
2
Views
2K
Optimal values for power in an induction heater?
Replies
2
Views
2K
Create High frequency High voltage signal
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top