How do I show that 2 moving objects collide?

AI Thread Summary
To demonstrate the collision of two moving objects, their positions must be equal at the same time. The expressions for the boat and branch positions were derived using equations, leading to the equation (2i, +j)t^2 = (-4i, +j)t - (16i, +2j). The discussion highlighted the importance of separating the vector equation into scalar components for accurate analysis. Attempts to factorize the resulting equations revealed mistakes, particularly in the j component. Ultimately, graphing the positions over time confirmed the collision visually, aligning with the question's requirement to show that they collide.
SueJ
Messages
3
Reaction score
2
Homework Statement
We have a boat sailing at a uniform acceleration of (4i, +2j) from the origin, and a branch floating at a uniform velocity of (-4i, +j) starting from position (16i, +2j). Show that they collide, and give the time of the collision
Relevant Equations
1. d=ut+1/2(at^2)
2. v^2=u^2+2ad
3. v=u+at
4. d=t(u+v)/2
They collide when their positions are the same, so I plugged the information for the boat into equation 1 to get an expression for d which is (2i, +j)t^2

Then I used equation 4 to get an expression for d for the branch, which is (-4i, +j)t

I would need to take into account the different starting position for the branch by subtracting it from the branch side

So they collide when (2i, +j)t^2 = (-4i, +j)t - )16i, +2j)

I then tried to factorise it, and this is where I got stuck!
 
Physics news on Phys.org
SueJ said:
by subtracting it from the branch side
Have another think about that.
SueJ said:
I then tried to factorise
Don’t forget that a 2D vector equation is really two scalar equations. Try writing them separately.
 
yep, you are right, thanks - ADD it to the branch side.
I did try separating the i and the j so I ended up with 2 quadratics - the one for i did factorise fine, the j one didnt - I may have made a mistake obviously - did you try it, and if so, did it factorise?
In order to SHOW that they collide, I just drew a graph of the postion of boat and branch at increasing t just to show that they cross - is this what would be expected for the question 'show that they collide'?
 
haruspex said:
Have another think about that.

Don’t forget that a 2D vector equation is really two scalar equations. Try writing them separately.
oh yes I did make a mistake and I got the same t for both I and j this time, thanks
 
  • Like
Likes berkeman
Thread 'Voltmeter readings for this circuit with switches'
TL;DR Summary: I would like to know the voltmeter readings on the two resistors separately in the picture in the following cases , When one of the keys is closed When both of them are opened (Knowing that the battery has negligible internal resistance) My thoughts for the first case , one of them must be 12 volt while the other is 0 The second case we'll I think both voltmeter readings should be 12 volt since they are both parallel to the battery and they involve the key within what the...
Thread 'Correct statement about a reservoir with an outlet pipe'
The answer to this question is statements (ii) and (iv) are correct. (i) This is FALSE because the speed of water in the tap is greater than speed at the water surface (ii) I don't even understand this statement. What does the "seal" part have to do with water flowing out? Won't the water still flow out through the tap until the tank is empty whether the reservoir is sealed or not? (iii) In my opinion, this statement would be correct. Increasing the gravitational potential energy of the...
Back
Top