LCR circuit, calculating R when frequency width is given

3 replies · 2K views · last reply
Pushoam
Messages
961
Reaction score
53

Homework Statement



Multiple-choice physics problem 16 on an AM radio receiver LC R circuit with L = 1.5 mH, asking for the resistance, with options 0.2, 2, 20, 200 and 2000 ohm.

Homework Equations

The Attempt at a Solution


Circuit schematic of a series loop with an inductor L between nodes A and B, a resistor R between B and C, and a capacitor C between C and A, with an arrow showing current direction and polarity marks on the capacitor.

LCR circuit, calculating R when frequency width is given

Applying Kirchoff Voltage Loop Law,

## V_A – V_B + V_B - V_C + V_C – V_A = 0 ## ...(2)

## V_A – V_B ## is potential drop across inductor. Since current is flowing from A to B, I tend to take ## V_A > V_B ## . This way I am taking inductor as a resistor. Inductor has a very low resistance. So, ## V_A – V_B ## , taking this way is negligible.

Since the current is decreasing through inductor, there will be an EMF across it. This EMF will tend to increase the current according to Lenz's law. This EMF = - L ## \frac { dI} {dt} ## = ## V_A – V_B ## ...(3)

I doubt whether (3) is correct.

From (2) and (3),

- L ## \frac { dI} {dt} + IR - \frac { q} C = 0 ##

Is this correct?
 
Attachments
  • Multiple-choice physics problem 16 on an AM radio receiver LC R circuit with L = 1.5 mH, asking for the resistance, with options 0.2, 2, 20, 200 and 2000 ohm.
    upload_2017-12-23_14-11-32.png
    17.8 KB · Views: 1,059
  • Circuit schematic of a series loop with an inductor L between nodes A and B, a resistor R between B and C, and a capacitor C between C and A, with an arrow showing current direction and polarity marks on the capacitor.
    upload_2017-12-23_16-16-27.png
    1.7 KB · Views: 1,055
Do you know some equations involving Q, the Quality Factor of a resonant circuit?
 
NascentOxygen said:
Do you know some equations involving Q, the Quality Factor of a resonant circuit?
In mechanics, I knew.
Q = ## \frac {\omega_0}{\Delta \omega}##
Here, ##\Delta \omega = \gamma = \frac b m ## where b is the coefficient of damping
I want to have a similar eqn for LCR circuit and then find out what is b and m in this circuit.
But I am stuck in applying emf across inductor = ## -L\frac {dI}{dT} ## in writing the second order linear differential eqn for the circuit.
I need help here.
 
Wikipedia has a decent coverage of the RLC circuit, including a relevant section on expressions for its Q :wink:

RLC Circuit
 
  • Like
Likes   Reactions: scottdave