Phasor diagram for circuit with capacitor and inductor

4 replies · 2K views · last reply
doktorwho
Messages
181
Reaction score
6

Homework Statement


From the given circuit and provided information draw a phasor and calculate the inductance.
Handwritten circuit schematic labelled Problème: a current source Ig in parallel with a capacitor C and a branch of resistor R in series with inductor L, nodes 1 and 2, current I, and Ic through the capacitor; below, values w = 10^7 s-1, I = Ig = 10 mA, C = 10 nF, R = 100 ohm, L = ?

Homework Equations


3. The Attempt at a Solution
Handwritten solution on lined paper: R = 100 Ω, L = ?, then a phasor diagram with I_C up, U_12 to the right, I_R and I at angle α, and I_C/2 marked, followed by sin α equations and the result L = 100 mH.
Handwritten phasor diagram with U12 as the horizontal reference, Ic drawn vertically upward, Ig and I as vectors, angle alpha between I and U12, and a bracket marking Ic/2; below it sin alpha = (Ic/2)/I = wL / sqrt(R^2 + (wL)^2).
[/B]
The paper was given to me at class as a solution to our homework and i can't understand how they drew the phasor and drew the conclusion out of it.
I see that they took ##U_{12}## as their phasor axis since its the same for both sides but why do they draw the ##I_c## the way they did? How did they know that it goes up and how did they get the ##I_c/2## part?
The continuation of the left side of the third equation i do get but not the right side. Why is the right side like that?
 
If the inductor were ideal (with R=0) then IC would lead I by 180°. If the inductance were zero, making it a simple parallel RC arrangement, then IC would lead I by 90°. So with both R and L then IC will lead I by some angle between those 2 extremes. That constrains the shape of triangle that you draw.

You also need to bring into the geometry the condition stated in your data of 2 currents having equal magnitude, viz., I = Ig
 
NascentOxygen said:
If the inductor were ideal (with R=0) then IC would lead I by 180°. g
Do you mean 90° ?
 
Numbskull said:
Do you mean 90° ?
No. I is the inductor current. Ic would lead U12 by 90° and if the inductor were ideal, inductor current I would lag behind U12 by 90°. This means Ic would lead I by 180°.
 
I believe that there is a flaw in the question as posed. Perhaps the angular frequency given is to high? If it is truly ##10^7 rad/sec## then the capacitor reactance is just 10 Ω. The real resistance of 100 Ω in the other branch will make it impossible for it to conduct a current with the same magnitude as the source current, even taking into account resonance effects. If I'm not mistaken the maximum magnitude for the current ##I## would be just 1 mA.