Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
Intro Physics Homework Help
Advanced Physics Homework Help
Precalculus Homework Help
Calculus Homework Help
Bio/Chem Homework Help
Engineering Homework Help
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
Intro Physics Homework Help
Advanced Physics Homework Help
Precalculus Homework Help
Calculus Homework Help
Bio/Chem Homework Help
Engineering Homework Help
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Homework Help
Engineering and Comp Sci Homework Help
Simple lever for a 3d printed gate
Reply to thread
Message
[QUOTE=".Scott, post: 6065633, member: 489053"] I would make two changes. First, I would not use that "Y" shape. I would use a full "door" with a "hindge" attached to the bottom of the assm. This would tend to keep the gates at the same level. Second, I would changes the way the gate is setup by the operator. You could make it so the operator needs to push the gates into a raised position - and flexing part of that "door" in the process. Then it would be held in that position until the trigger release it. That way the gates would snap down quickly. [/QUOTE]
Insert quotes…
Post reply
Forums
Homework Help
Engineering and Comp Sci Homework Help
Simple lever for a 3d printed gate
Back
Top