Temperature compensation circuit

10 replies · 2K views · last reply
AHMEDbr
Messages
16
Reaction score
0

Homework Statement


I am designing a local oscillator ( clapp ) whose frequency needs to be kept constant even with varying temperatures , this oscillator have an output frequency 150 MHZ , and power supply 3.3 V

Homework Equations


which temperature compensation circuit must be used with this oscillator ?

The Attempt at a Solution

 
Attachments
  • Schematic of a Clapp oscillator with JFET J1 (2N5484), inductor L1 240n, capacitors C1 and C2 33p, C3 6p, resistors R1 1k and R2 47k, and a 3.3 V supply V1, with output labelled out.
    clapp oscillator circuit.PNG
    3.4 KB · Views: 674
AHMEDbr said:

Homework Statement


I am designing a local oscillator ( clapp ) whose frequency needs to be kept constant even with varying temperatures , this oscillator have an output frequency 150 MHZ , and power supply 3.3 V

Homework Equations


which temperature compensation circuit must be used with this oscillator ?

The Attempt at a Solution

What are your thoughts? What component values or qualities vary in that circuit with temperature?
 
the JFET and all the others components because I'm working in HF also i will use electrodes in parallel with C3 for measure soil moisture , and the measurement is sensible to temperature variation
 
AHMEDbr said:
the JFET and all the others components because I'm working in HF also i will use electrodes in parallel with C3 for measure soil moisture , and the measurement is sensible to temperature variation
So what are your initial thoughts to be able to do temperature compensation? What-all changes in the FET? Are you supposed to ignore the tempcos of the capacitors and other passives?
 
I don't see any design target for temperature stability. What is an acceptable range for the oscillator frequency?How do you plan on measuring or calculating it?

What's the anticipated operating temperature range? How does your existing circuit behave over that range? (so how much effort do you need to put into make it conform to requirements?)

Would you change the oscillator circuit type if you find that the required compensation is too complex to be practical?
 
i can use à temperature sensor with a voltage controlled capacitor to compensate temperature , i found in net analog device AD590 but it power supply is +5 V , my circuit power supply is 3.3 V so i must use another temperature sensor
 
below is an example of thermal compensation circuit
 
Attachments
  • Circuit schematic of a radio-frequency oscillator and regulated supply, with transistors BFR90 and 2N2222A, IC1 SP8782, IC2 AD590, IC3 ICL7621 op-amps, and two red-outlined regions marking the diode and op-amp sections.
    AD590.png
    17.1 KB · Views: 548
because the oscillator will have a variable frequency output , so crystal oscillator is not the best choice
 
AHMEDbr said:
because the oscillator will have a variable frequency output , so crystal oscillator is not the best choice
That's what crystal-based synthesizer ICs are for. Have you looked at them yet?