What is the terminal velocity of a ping pong ball?

AI Thread Summary
The terminal velocity of a ping pong ball is approximately 9.5 m/s, which is reached after falling about 12.5 meters. The discussion explores how long it takes for the ball to reach this speed, with a focus on the calculations involved. A specific equation is provided to determine the velocity at intervals until terminal velocity is achieved, but there is confusion about how to apply it. Participants encourage sharing previous attempts to clarify the problem-solving process. Understanding the physics behind terminal velocity is essential for accurately answering the question.
guitarhero123
Messages
2
Reaction score
0
1. How long does it take a ping pong ball to reach terminal velocity?
2. What is the terminal velocity of a ping pong ball?
 
Physics news on Phys.org
Welcome to PF!

guitarhero123 said:
1. How long does it take a ping pong ball to reach terminal velocity?
2. What is the terminal velocity of a ping pong ball?

Hi guitarhero123! Welcome to PF! :wink:

Is this a theory or an experiment question?

Anyway, show us what you've tried, and where you're stuck, and then we'll know how to help. :smile:
 
The Terminal Velocity is about 9.5 m/s

98% of which is attained after falling 12.5 m. (Im not sure of the time it takes to get to this)

Did you want to know the values? Or the working?

I can't help you with the working, I simply found an answer from a quick google search.

http://adsabs.harvard.edu/abs/1984AmJPh..52..890B" is the site.
 
Last edited by a moderator:
I wasn't sure how to start working out the problem.
I was given this equation Vi+1=Vi+(g-c^2/m*Vi^2)t
im not sure if that makes sense or not i think its supposed to read velocity initial plus one equals velocity initial plus the quantity gravity minus c squared over mass times initial velocity squared times the change in time
We were told to determine the velocity every .1 second until we reach terminal velocity.
I'm sorry if this doesn't make sense I'm really lost.
 
Hello everyone, Consider the problem in which a car is told to travel at 30 km/h for L kilometers and then at 60 km/h for another L kilometers. Next, you are asked to determine the average speed. My question is: although we know that the average speed in this case is the harmonic mean of the two speeds, is it also possible to state that the average speed over this 2L-kilometer stretch can be obtained as a weighted average of the two speeds? Best regards, DaTario
The rope is tied into the person (the load of 200 pounds) and the rope goes up from the person to a fixed pulley and back down to his hands. He hauls the rope to suspend himself in the air. What is the mechanical advantage of the system? The person will indeed only have to lift half of his body weight (roughly 100 pounds) because he now lessened the load by that same amount. This APPEARS to be a 2:1 because he can hold himself with half the force, but my question is: is that mechanical...
Thread 'Beam on an inclined plane'
Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...

Similar threads

Replies
19
Views
3K
Replies
5
Views
3K
Replies
20
Views
2K
Replies
6
Views
2K
Replies
1
Views
4K
Replies
19
Views
17K
Back
Top