The details of Boron 10 isotope

  • Thread starter Thread starter david allen
  • Start date Start date
  • Tags Tags
    Isotope
AI Thread Summary
The discussion focuses on the need for specific scientific data regarding Boron-10, particularly its ion density and ion mass, as these values are essential for calculating the frequency of the particle isotope BF3. There is a request for clarification on the information needed, indicating potential confusion in communication. The inquiry emphasizes the importance of accurate data in isotope frequency calculations.
david allen
Messages
9
Reaction score
0
Hi
I am looking for ion density an ion mass of Boron 10, the particle of BF3 but I could not figure out these 2 number yet. I really need them to calculate the frequency of the particle isotope. any help would be appreciated.
 
Chemistry news on Phys.org
Please elaborate, it is not clear to me what it is that you are looking for, most likely it is a language related problem.
 

Thread 'Humidity of a saturated NaCl solution with anticaking additive'

I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
View full post »

Thread 'Why does having 8 valence electrons make an element inert?'

I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
View full post »

Thread 'Resists for etching Aluminium with NaOH'

I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
View full post »

Similar threads

Why wasn't fluorine used as a standard for atomic mass?
Replies
6
Views
3K
I Energy reduction/deflection of beta particles due to isotope geometry
Replies
2
Views
2K
I What is theoretically the heaviest isotope that the R-process could produce?
Replies
11
Views
2K
Isotope decay via alpha and beta particle emissions
Replies
1
Views
1K
Calculate the isotopic shift of the analogue states for Cr and Mn
Replies
2
Views
1K
A Pandora's Box: Carbon-14 vicious cycle from transmutation
Replies
1
Views
3K
I Stopping power for a proton ion gun through a Boron-11 sheet 1mm thick
Replies
2
Views
2K
Distance between Isotopes in a mass spec
Replies
8
Views
10K
Physical details of the operation of galvanic cells
Replies
2
Views
2K
Mass of ions with respect to amu
Replies
1
Views
6K

Hot Threads

Recent Insights

Back
Top