Register to reply

Force on Solenoid Plunger

by Kalagaraz
Tags: force, plunger, solenoid
Share this thread:
Kalagaraz
#1
Mar4-13, 07:24 PM
P: 28
I'm trying to figure out how to calculate the actual physical force on a solenoid plunger. I.E what kind of load it can pull or push.

So if I setup a magnetic circuit and calculate the flux going through it at maximum airgap, am I right to assume that the force is equal (B^2 * A) / (2*u) where B is the flux density at end of plunger, A is the cross sectional area at end of plunger, and u is the magnetic permeability of a vacuum? Obviously force would increase as the air gap closes, but I really only need to know worst case scenario and best case scenario (no air gap).

B would be the flux divided by cross sectional area at end of plunger?

Thanks.
Phys.Org News Partner Physics news on Phys.org
Physicists unlock nature of high-temperature superconductivity
Serial time-encoded amplified microscopy for ultrafast imaging based on multi-wavelength laser
Measuring the smallest magnets: Physicists measured magnetic interactions between single electrons

Register to reply

Related Discussions
Friction force calculation of syringe plunger General Physics 4
Coil force to the plunger Electrical Engineering 0
Coil force to the plunger Classical Physics 0
Magnetic Circuit Problem Involving a Solenoid and Plunger Advanced Physics Homework 2
Solenoid with plunger Classical Physics 4