Register to reply 
Band density of states 
Share this thread: 
#1
Aug1613, 07:59 AM

P: 895

For an electron gas generated in the inversion layer of a semiconductor interface, my book gives the conduction band density of states for the two dimensional electron gas as:
##g(E)=\frac{L^2m^*}{\hbar^2 \pi}## Where m^{*} is the effective mass of the electron. I can't follow how this was exactly derived. So the density of state is given by ##g(E)=2g(k) \frac{dk}{dE}## Where ##E=\frac{(\hbar k)^2}{2m} \implies \frac{dE}{dk}= \frac{\hbar^2 k}{m}## And also the density of states per spin: ##g(k) k dk = 2 \frac{L_x L_y}{\pi} k dk## Hence substituting I've got: ##g(E) = \frac{2\times 2 L^2 k m}{\pi \hbar^2 k} =\frac{4L^2 m}{\hbar^2 \pi}## But why do I end up with a "4" on the numerator? Did I make a mistake, or is that a typo in the book? Any response is greatly appreciated. 


#2
Aug1613, 10:23 AM

P: 419

I don't know why you have L_{x} and L_{y}are you referring to spin operators? (They would typically have the symbol S rather than L which is orbital angular momentum). L here refers to the size of the 2DEG (L~"length" of a side) and not to anything related to angular momentum. The factor of 2 you have in your second formula is there to correct for spin degeneracy, so you've taken care of spin problems already.
The way I always do DOS calculations is by plotting the momentum eigenstates on the axes (k_{x}, k_{y}), then drawing an annular region of radius k and width dk and calculating how many eigenstates would on average lie inside the first quadrant of that annulus. This recipe immediately generalizes to higher dimension if you remember the surface areas of nspheres. That was a quick description so let me spell it out. So the calculation would go like this: First solve the schrodinger equation for the 2dimensional square with side length L using appropriate boundary conditions. You get k_{x}=n_{x}π/L k_{y}=n_{y}π/L. Now go ahead and draw these on the (k_{x},k_{y}) axes. Each pair (n_{x}, n_{y}) occupies a region of area (π/L)^{2}. Thus there is, on average, one state per area (L/π)^{2} in kspace. Now we want to know how many states lie in the region between k=(k_{x}^{2}+k_{y}^{2})^{1/2} and k+dk. This region would have the shape of an annulus, but since k_{x} and k_{y} must be positive, we are only concerned with the first quadrant. The area of that region would be dk*(2πk)*(1/4)=πk/2 dk. The number of states in this area would thus be (L/π)^{2} * nk/2 dk = L^{2}k/(2π) dk Now we want to substitute back using E=( dE = Thus k = (2mE)^{1/2}/ dk = dE/ Thus we have that the number of states in the area is L^{2}k/(2π) dk = L^{2}/(2π) (2mE)^{1/2}/ Now since we have done everything so far without regards to spin degeneracy, we multiply the last expression by 2 and we get the right answer. PS: sorry if it is hard to follow when I write fractions if there is a space after a term in a denominator, then the space should be an implicit multiplication sign. As an example, rs/p yz = yzrs/p 


#3
Aug1713, 04:20 AM

P: 895

Thank you very much for your response. I see that the factor of 2 accounts for spin, and the calculation makes perfect sense now.
I have another relevant question: my book says that the conduction electron density is given by ##n = \frac{m^* k_B T}{\hbar^2 \pi} \ln (e^{(\muE_c)/k_B T}+1)## But I can't get to this using the equation we found for density of states. Electron density is given by density of states multiplied by the FermiDirac distribution function (the most probable number of particles in a particular state with energy E): ##n(E)=g(E) f(E,T)## So ##n(E)=\frac{L^2m^*}{\hbar^2 \pi} \frac{1}{e^{(E\mu)/k_B T}+1}## But this is not the right equation. Am I using the wrong formula? Or does it have to be calculated in a different way? Much appreciated 


#4
Aug1713, 05:43 PM

Sci Advisor
P: 1,625

Band density of states
##n=\int g(E) f(E,T) dE##



#5
Aug1813, 06:57 AM

P: 895

Thank you very much for the helpful post, completely missed the integral.



Register to reply 
Related Discussions  
How to analyze band structure and the density of states?  Atomic, Solid State, Comp. Physics  0  
Number of states in a band  Advanced Physics Homework  1  
Density of states in anisotropic conduction band valley  Advanced Physics Homework  1  
Number of states in a band  Atomic, Solid State, Comp. Physics  5  
What is the essentail difference between local density of states and density of state  Atomic, Solid State, Comp. Physics  2 